PowerLite 1915/1925W
9. Select your IP Settings as necessary:
• If your network assigns addresses automatically, turn on the DHCP setting.
• If you must set addresses manually, turn off DHCP and enter the projector's IP Address, Subnet
Mask, and Gateway Address as needed.
Note: To highlight the numbers you want from the displayed keyboard, press the arrow buttons on
the remote control. To select a highlighted number, press Enter.
10. To prevent display of the IP address on the standby screen, turn off IP Address Display.
Parent topic: Wired Network Projection
Wireless Network Projection
You can send images to your PowerLite 1915/1925W projector through a wireless network. To do this,
you must install the Epson 802.11g/b/a wireless LAN module, and then set up your projector and
computer for wireless projection.
There are two ways to connect the projector to your wireless network:
• Using the optional Epson Quick Wireless USB Connection key.
• Configuring the connection manually using the projector's Network menus.
54
To Next Page
Loading...
