Epson PowerLite 1830 User Manual

7. Select the Wireless LAN menu and press Enter.
8. Select one of the following connection modes:
• Quick mode lets you easily connect one computer to the projector at a time. You can also select
this setting when you're using the optional Epson Quick Wireless Connection USB key.
• Advanced mode lets multiple computers access the projector at the same time and easily trade
off control of the projector. This method requires a wireless network access point or an AirPort
Extreme (or AirPort) base station.
Note: The wireless network card or access point must comply with the 802.11g, 802.11b, or 802.11a
standard.
9. Click To Setup Wizard if your access point is compatible with Wi-Fi Protected Setup (WPS), and
you want to use the Push Button or PIN Code method to configure the projector.
10. Enter the SSID (network name) for your existing wireless network.
11. Select your IP settings as necessary:
• If your network assigns addresses automatically, turn on the DHCP setting.
• If you must set addresses manually, turn off DHCP and enter the projector's IP Address, Subnet
Mask, and Gateway Address as needed.
12. To prevent display of the SSID on the network standby screen, turn off SSID Display.
60

Epson PowerLite 1830 Specifications

General

Brand	Epson
Model	PowerLite 1830
Category	Projector
Language	English