Wireless LAN
4. Enter up to two IP addresses to receive SNMP notifications, using 0 to 255 for each address field.
Note: Do not use these addresses: 127.x.x.x or 224.0.0.0 through 255.255.255.255 (where x is a
number from 0 to 255).
5. If available, select Wired or Wireless for the Priority Gateway setting.
6. If your network environment uses an AMX controller, turn on the AMX Device Discovery setting to
allow the projector to be detected.
Parent topic: Using the Projector on a Network
68
To Next Page
Loading...
