Two Connection Modes
10
Preparing to Connect
Follow the steps below to connect the computer and the projector via a
network using EasyMP Network Projection.
A Install EasyMP Network Projection on the computer to be
connected.
s "Installing" p.7
B Make network settings on the computer and put it into
network connection status.
See the documentation supplied with your the computer, LAN
adapter, or AirMac card for details on network settings.
q
When the computer you are using is normally connected to the network,
you do not need to make network settings on the computer.
C For Quick Connection Mode
Install the Wireless LAN unit to the projector.
For Advanced Connection Mode
Make network settings on the projector and put it into network
connection status.
You can make network settings from the projector's Network
menu.
See your projector User’s Guide for details.
D Press the LAN button on the remote control.
The LAN standby screen is displayed.
If there is no signal for the current input source, it automatically
switches to the LAN source. If it does not automatically switch to
the LAN source, press the LAN button.
E Start EasyMP Network Projection on the computer and
connect with the projector.
s "Connecting to a Projector on a Network and Projecting" p.11
q
If a connection error occurs, a number indicating the type of error is
displayed as follows.
Event ID: 04xx
See your projector User’s Guide for details on Event ID.
To Next Page
Loading...
Need help?
Operating Environment
Power
Display
Weight and Dimensions
