Epson PowerLite 1835 Operation Guide

Troubleshooting
41
Cannot connect the projector and the computer via wired LAN.
Cannot connect the projector and the computer via the network.
Check Remedy
Are the computer's LAN card and the built-in LAN function
available?
Check that LAN is available from the device manager under Control Panel - System - Hardware.
Is the network cable connected correctly? Check that the network cable is connected correctly. Reconnect it if it is not connected or not
connected properly.
Check Remedy
Is the network configuration screen displayed on the
projector?
Close network settings on the projector, and return to the LAN standby screen. If the network
configuration screen is displayed on the projector, you cannot connect using EasyMP Network
Projection.
Was the network adapter used selected correctly with
EasyMP Network Projection?
If the computer has multiple LAN environments, it cannot connect unless the network adapter is
selected correctly. When using a computer running Windows, start EasyMP Network Projection and
select the network adapter you are using from Set options - Switch LAN.
s "General settings tab" p.34
Is the firewall turned off, or has the firewall been
registered as an exception?
When you do not wish to turn off the firewall or register the firewall as an exception, make the
necessary settings to open the ports.
The ports used by EasyMP Network Projection are "3620", "3621", and "3629".
Is the SSID setting different?
(For Advanced Connection Mode)
Set the computer, the access point, and the projector to the same SSID.
You can make the SSID setting from the projector's Network menu.
See your projector User’s Guide for details.
Are the connection denial functions, such as MAC
Addressg restrictions and port restrictions, set correctly at
the access point?
(For Advanced Connection Mode)
Set connection permission at the access point to allow projectors to connect.

Epson PowerLite 1835 Specifications

Operating Environment

operating temperature range	41 ˚ to 95 ˚F (5 ˚ to 35 ˚C)
fan noise (normal mode)	37 dB
fan noise (eco mode)	29 dB

Power

power supply voltage	100 – 240 V ± 10%, 50/60 Hz AC
power consumption (normal mode)	355 W
power consumption (eco mode)	263 W

Display

projection method	front/rear/ceiling mount
native resolution	1024 x 768 (XGA)
aspect ratio	4:3

Lamp

lamp type	E-TORL 230 W UHE
lamp life (normal mode)	4000 hours
lamp life (eco mode)	6000 hours

Weight and Dimensions

dimensions including feet	13.58" x 10.35" x 5.17"
dimensions excluding feet	13.58" x 10.35" x 3.66"
weight	7.4 lb