Epson PX-8 - Page 184

REV.-A
Lock
button
cover
Board
Disassemble Procedure
Step 1. Remove keyboard cover.
Stpe 2. Place
the body as shown in Fig. 4-2,
and remove screw pointed by arrow.
Step 3.
Lift up cover slowly from right side.
Step
1. Remove lock button cover.
Step 2. Remove connector.
Step 3. Remove
FPC cable from connector
CN4.
Step 4.
Remove cables from CD, CD and CD.
Step 5. Remove three screws pointed by ar-
rows.
Step 6. Lift up board slowly from your side.
Fig. 4-3
Fig. 4-4
4-3
Assemble Procedure
Perform the reverse procedure to disassem-
ble.
Fig. 4-2
Step 1. Place PX-8 with lower case being
removed.
Step 2. Put jack
connector CD into specified
hole.
Step 3. Place board slowly.
Step 4. Fit three
screws pointed by arrows.
Step 5. Fit cables
to connectors CD, CD and
CD.
Step 6. Remove lock button cover and
insert
the FPC cable to connector
(CN4).
Step 7.
After fitting the cable to the connec-
tor CD, insert cable between case
and boss paying
attention not to
damage the cable. (see Fig. 4-4.)
-~