Epson PX-8 - Page 200

REV.-A
Step 6.
Step 7.
Step 8.
Replace the battery cover - care should be taken
not to pinch the battery wires at
the set screw.
Tighten the battery cover set screw.
Open the
ROM capsule cover.
o
CJ
o 0
- - ROM capsule cover
Fig. 4-40 ROM Capsule Cover
Step 9. Push once the INITIAL RESET switch located above the ROM cover.
Fig.4-41 Access to INITIAL RESET Switch
Step 10. Replace the ROM capsule cover.
After above procedures, change the battery by connecting the AC adaptor. Never discard the bat-
tery
into water or in fire, nor disassemble.
4-19