Epson PX-8 - Page 297

REV.-A
Pin No. Signal Name
In/Out
Function
--
11
INTO In Sub-CPU 7508 interrupt signal
12 SWBCD
Out Barcode
power supply (+5V) switching sig-
nal
13 RXC
Out Clock which controls receive character
synchronization (RS-232C).
14
BCD In Bar code read data
15 CSIO
In HIGH: Indicates that sub-CPU 7508 can ac-
cess
SIOR.
LOW:
Indicates that main CPU can read/
write.
16 SI In Serial data input from sub-CPU 7508.
17
SO
Out Serial data output to sub-CPU 7508.
--
18 S-INT
Out
Interrupt signal to main CPU. Gives an inter-
rupt via
GAH40D (Z-INT signal).
19 DB5
In/Out Data bus 5
20 DB3
In/Out Data bus 3
21
N/C
-
Not used.
22
N/C
-
Not used.
23
N/C
-
Not used.
24
N/C
-
Not used.
25
N/C
-
Not used.
26 SWRS
Out
Switching signal for RS-232C power supply
27 INHRS Out Controls output voltage during power satura-
tion
time of RS-232C.
28 OFF
In
Power off. To prevent latch-up by isolating
output in high impedance.
29
G
-
Ground
30 TEST In Test terminal.
Normally kept
low level.
31
N/C
-
Not used.
32
AUX Out RS-232C transmit/receive line control
7-26