Settings item Settings value Explanation
Device Name Set the name of the printer to use on the network.
TCP/IP
Auto
*
Automatically assign the printer IP address using DHCP functionality
in the router.
Manual Select this to manually assign a fixed IP address, then input the IP
address, subnet mask, and other required information.
Proxy Server Use When using a proxy server to directly connect from the intranet to the
Internet so that the printer may directly access the Internet for
firmware updates or similar, select Use, and set the server name and
port number.
Do Not Use
*
IPv6 Address
Enable
*
Select whether to enable or disable the IPv6 function.
Disable
Link Speed & Duplex
Auto
*
Normally, set this to Auto.
10BASE-T Half Duplex
10BASE-T Full Duplex
100BASE-TX Half Duplex
100BASE-TX Full Duplex
Redirect HTTP to
HTTPS
Enable
*
Select whether to enable or disable the function to auto-redirect HTTP
to HTTPS.
Disable
Disable IPsec/IP Fil-
tering
Enable To enable IPsec/IP filtering functionality, use Web Config.
Disable
*
Disable IEEE802.1X Enable To enable IEEE802.1X functionality, use Web Config.
Disable
*
SC-F500 Series User's Guide
Using the Menu
105
To Next Page
Loading...
Need help?
General
