Item Parameter Explanation
Nozzle Check between Pages
On When On is set, a nozzle check pattern is printed periodically at the
specified timing. When printing is complete, you can visually inspect
the check pattern to determine whether there are any stripes or
unevenness in the preceding or following printout.
Select one of Print Length, Pages, or Print Duration to set the timing
for printing the check pattern.
Execution Timing
Print Length
1 to 9999 m (99 m
*
)
(3.28 to 32805.12 ft
[324.80 ft
*
])
Print Page 1 to 9999 pages
Print Duration 1 to 9999 minutes
Off
*
Information Printing
Media Remaining
Information
On Prints information, such as the remaining amount of media, when
media is removed or replaced.
When Media Remaining Information is set to On, the remaining
amount is printed on the unused side of the cut position. The following
information is printed. To print the media remaining information, set
Remaining Amount Management in Media Settings to On.
❏ Model: Model name of the printer
❏ Serial No.: Serial number of the printer
❏ Print Date: Date and time of printing
❏ Bank No.: Media number when printing
❏ Media Type: Media Type registered to the media number when
printing
❏ Media Width: Automatically detected value of media width
❏ Remaining Amount: Remaining amount of media
When Print Information is set to On, the following information is
printed on the printed side of the cut position.
❏ Model: Model name of the printer
❏ Serial No.: Serial number of the printer
❏ F/W Version: Firmware version of the printer
❏ Print Date: Date and time of printing
❏ Bank No.: Media setting number when printing
❏ Media Type: Media Type registered to the media setting number
when printing
❏ Media Width: Automatically detected value of media width
❏ Print Length: Amount of media used
Off
*
Print Information On
Off
*
SC-F6400 Series/SC-F6400H Series User's Guide
Control Panel Menu
75
To Next Page
Loading...
Need help?
General