Epson STYLUS 400 - Removing the Control Panel

Disassembly and Assembly
EPSON Stylus COLOR 400 Service Manual
3
-
9
3.2.3 Removing the Control Panel
1. Remove the housing. (See Section 3.2.1)
2. Remove 2 screws (No. 1) securing the control panel, and disconnect the panel from the printer
mechanism.
3. Remove 1 screw (No. 1), and detach the left panel housing.
4. Remove 2 screws (No. 3) securing the panel board assembly and take C206 PNL board out of the panel
assembly.
5. Disconnect the FFC from the connector on the C206 PNL board.
Removing the control panel also separates the stacker assembly, because the control panel is attached
to the stacker assembly.
Stacker Assembly
Left Panel Housing
Panel Assembly
Panel Shield Plate
Panel Board Assembly
(No. 1)
(No. 3)
(No. 1)
Figure 3-5. Removing the Control Panel