EPSON Stylus COLOR 600
18 - EPSON Stylus COLOR 600 1/97
Caution:
Never turn off the printer while the
Ppower light is
flashing.
6. Make sure paper is loaded in the printer and click Print
nozzle check pattern
(Windows) or Confirmation
(Macintosh). See the section below for instructions on
examining the nozzle check pattern.
If your print quality has not improved, repeat the steps above.
Using the Control Panel
1. Make sure the printer is turned on and not printing, and
that the
B black and A color ink out lights are off.
2. Press the
R cleaning button and hold it for three seconds.
Cleaning takes about two minutes, during which the printer
makes some noise and the
Ppower light flashes.
After the cleaning cycle is complete and the
Ppower light
stops flashing, you need to run a nozzle check.
3. Access the Main printer settings dialog box.
4. Click the
Utility tab (Windows) or the Utility button
(Macintosh). You see the Utility menu.
5. Click the
Nozzle Check icon. See the next section for
instructions on examining the nozzle check pattern.
If your print quality has not improved, repeat the steps above.
Examining the Nozzle Check Pattern
Examine the nozzle check pattern you print. It should look
something like this, with the lower pattern colored cyan,
magenta, and yellow:
Each staggered horizontal and straight vertical line should be
complete, with no gaps in the dot pattern. If your printout
looks okay, you’re done. If any dots are missing, clean the
print heads again, as explained in the previous sections.
Aligning the Print Heads
If your printouts contain misaligned vertical lines, you may
need to align the print heads. Follow these steps:
1. Make sure the printer is turned on and paper is loaded.
2. Access the Main printer settings dialog box.
Caution:
Load paper that’s at least 8.3 inches wide so ink
doesn’t spray onto the platen.
3. Click the Utility tab (Windows) or the Utility button
(Macintosh). You see the Utility menu.
4. Click the
Print Head Alignment icon.
5. Follow the instructions on the screen to print a test page
and select the correct alignment.
Cleaning the Printer
To keep your printer working at its best, you should clean it
several times a year, following these steps:
1. Turn off the printer, unplug the power cord, and
disconnect the printer cable.
Caution:
Don’t touch the gears inside the printer.
Never use alcohol or thinner for cleaning; they can
damage the printer components and case.
Don’t use a hard or abrasive brush.
Don’t get water on the printer components.
Don’t spray lubricants or oils inside the printer.
2. Remove all the paper from the sheet feeder.
3. Carefully clean away dust and dirt with a soft, damp cloth.
4. Clean the exterior of the printer with a soft, damp cloth.
Keep the printer cover closed so water doesn’t get inside.
5. Clean ink out of the printer’s interior with a soft, damp
cloth.
Information Reference List
Engineering Change Notices None
Product Support Bulletins None
Technical Information Bulletins None
Related Documentation
TM-STYCLR600 EPSON Stylus COLOR 600 Service
Manual
PL-STYCLR600 EPSON Stylus COLOR 600 Parts Price
List
4006673 EPSON Stylus COLOR 600 User’s Guide
4006672 EPSON Stylus COLOR 600 Quick Setup
To Previous Page
Loading...
Need help?
General