Epson Stylus CX7300 - Page 83

83
Encender (On) light
flashing
If the other lights are off and you cannot use the Epson Stylus
CX7300 Series, it may be in sleep mode. Press any button
(except the Encender (On) button) to wake it up.
paper light on
Paper is out or multiple pages have fed. Load
or reload paper
in the sheet feeder, then press one of the Iniciar (Start)
buttons to continue.
paper light flashing
Paper is jammed. Carefully remove the jam.
ink light flashing
One or more cartridges have low ink. You can continue
printing until a cartridge needs replacement. C
heck the
cartridge status to determine which cartridges are affected.
ink light on
An ink cartridge is expended or incorrectly installed.
If an ink cartridge is likely to be expended, you must replace
the cartridge to be able to print.
If you just replaced a cartridge and the light is still on, the
cartridge is not installed correctly. Press the Cancelar
(Stop) button to move the cartridges to the replacement
position. Press down on all the installed cartridges, then press
the Cancelar (Stop) button to continue.
paper light flashing
Copias (Copias) window
The inserted memory card is not supported or does not
contain compatible photos. Remove it and insert another
card.
paper light flashing
Copias (Copias) window
The index sheet is not positioned correctly or is not marked
correctly. Check the marks on the sheet, position it correctly,
and print it again.
paper light flashing
Copias (Copias) window
The index sheet is not marked correctly. Check
the marks on
the sheet, position it correctly, and print it again.
paper light flashing
Copias (Copias) window
The index sheet you’re printing from does not match the
photos on the inserted memory card. Replace the card or the
sheet
and try again.
paper light flashing
Copias (Copias) window
The connected USB hub is not supported. Disconnect the
hub.
paper light flashing
Copias (Copias) window
The connected USB device is not supported. Disconnect the
device and press the Cancelar (Stop) button to continue.
Light/Copies window status Problem and solution