Epson Stylus CX7300 - Page 84

84
Run a Printer Check
A printer check will help you determine if the Epson Stylus CX7300 Series is operating properly.
1. Turn off the Epson Stylus CX7300 Series and your computer, if connected.
2. Disconnect any connected USB cables.
3. Load plain paper in the sheet feeder.
4. Hold down the Cancelar (Stop) button as you press the Encender (On) button to turn
the Epson Stylus CX7300 Series back on. Hold down both buttons until the Encender (On)
light begins to flash, then release the buttons.
5. The Epson Stylus CX7300 Series begins printing the nozzle check pattern.
• If the page prints, your Epson Stylus CX7300 Series is operating. Your problem may be
caused by your computer, cable, software, or setting selections. Check for additional
solutions or re-install your software.
If the pattern on the page has gaps, clean or align the print head.
• If the page does not print, the Epson Stylus CX7300 Series may have a problem. Check
for additional solutions. If they don’t work, contact Epson.
Encender (On) light
flashing
paper light on
ink light on
Copias (Copias) window
Parts inside the Epson Stylus CX7300 Series are at the end of
their service life. Contact Epson for help.
Encender (On) light
flashing
ink light flashing
paper size light flashing
Copias (Copias) window
There is a problem with the Epson Stylus CX7300 Series.
Turn it off, wait a few moments, and turn it back on again. If
the error is not resolved, contact Epson for help.
Light/Copies window status Problem and solution