Epson Stylus OFFICE B30 - Panel Unit

EPSON Stylus C110/C120/D120/WorkForce 30/EPSON Stylus OFFICE B30/T30/T33/ME OFFICE 70 Revision C
DISASSEMBLY/ASSEMBLY Removing Board 71
Confidential
4.4.2 Panel Unit
 Part/Unit that should be removed before removing Panel Unit
Upper Housing
 Removal Procedure
1. Peel off the Panel Unit FFC that is secured with the double-sided tape (x1) from
the Panel Unit, and disconnect the FFC (x1) from the connector of the Panel Unit.
2. Release the rib (x1) of the Panel Unit from the cutout (x1) of the Front Frame, and
remove the Panel Unit.
Figure 4-18. Removing Panel Unit
 When routing the Head FFC on the Left Frame, secure the
Head FFC with an acetate tape on the specified position as
shown in the figure below.
Figure 4-16. Acetate Tape Position
 Be cautious of the following points when connecting the cables
to the Main Board.
1. Do not let the cables and FFCs over the USB interface.
2. Route the CR Motor cable and the PF Motor cable through the
gap between their connectors.
.
Figure 4-17. Routing cables on the Main Board
A D J U S T M E N T
R E Q U I R E D
After replacing the Main Board Unit, be sure to perform specified
adjustment. See
Chapter 5 “ ADJUSTMENT” (p.98)
50 mm
Align the edge of the tape with
the corner of Left Frame.
Align here with
the cutout of the
Left Frame.
Inside of the frame
Wrap the tape around the
frame and the Head FFC.
Outside of the frame
2
1
USB Interface
Panel Unit
Connector of the
Panel Unit FFC
Rib and Cutout
Marking-off Line
Tape position