Epson Stylus OFFICE B30 - Ink System Unit

EPSON Stylus C110/C120/D120/WorkForce 30/EPSON Stylus OFFICE B30/T30/T33/ME OFFICE 70 Revision C
DISASSEMBLY/ASSEMBLY Disassembling Printer Mechanism 92
Confidential
4.5.16 Ink System Unit
 Part/Unit that should be removed before removing Ink System Unit
Upper Housing/Lower Housing/Main Board Unit/Left Frame/Panel Unit/Front
Frame/Right Frame/CR Motor/CR Scale/Hopper/Main Frame Assy./ASF Unit
 Removal Procedure
 When installing the ASF Unit, be sure to align the guide pins
(x2) of the Base Frame with the positioning holes (x2) of the
ASF Unit shown in the
Figure 4-70.
 When routing the PE Sensor cable, pay attention to the
following instructions.
• Route the cable in the order given in Figure 4-68.
• Make sure to face the blue line of the cable toward the Base
Frame.
Figure 4-72. Routing PE Sensor Cable
• Check if there is no slack in the cable.
A D J U S T M E N T
R E Q U I R E D
 After removing/replacing the ASF Unit, be sure to perform the
specified adjustment. See
Chapter 5 “ ADJUSTMENT” (p.98)
 After replacing the ASF Unit, be sure to perform the required
lubrication. See
Chapter 6 “ MAINTENANCE” (p.107)
PE Sensor Cable
C A U T I O N
When disassembling/assembling the Ink System Unit, pay attention
to the following instructions.
 Be cautious not to get injured with the sharp metal edges of the
Frame Support.
Figure 4-73. Sharp Edges of Frame Support
 Do not touch or damage the Sealing Rubber or the Head
Cleaner.
 Mark the connection location before removing the Ink Tube.
Frame Support