Epson Stylus OFFICE B30 - Page 93

EPSON Stylus C110/C120/D120/WorkForce 30/EPSON Stylus OFFICE B30/T30/T33/ME OFFICE 70 Revision C
DISASSEMBLY/ASSEMBLY Disassembling Printer Mechanism 93
Confidential
1. Detach the Waste Ink Tube together with the Tube Stopper from the Waste Ink
Cover.
2. Detach the Waste Ink Tube from the groove of the Base Frame.
Figure 4-74. Detaching Waste Ink Tube
3. Remove the screw that secures the Ink System Unit (x1).
4. Slide the Ink System Unit in the direction of the arrow while releasing its hook
with flathead precision screwdriver, and remove the Ink System Unit.
Figure 4-75. Removing Ink System Unit
Waste Ink Cover Tube Stopper
Waste Ink Tube
Groove
C.B.P. 3x6, F/Zn-3C (6±1kgfcm)
Hook
Ink System Unit
 If the Carriage lock lever comes off, reassemble it following
the steps below.
1. Attach the one end of the Extension Spring 0.8 to the hook
of the Carriage Lock Lever.
2. Attach the another end of the Extension Spring 0.8 to the Ink
System Unit.
3. Insert the dowel (x1) of the Carriage Lock Lever into the hole
(x1) of the Ink System Unit.
Figure 4-76. Installing Carriage Lock Lever
Carriage Lock Lever
Extension Spring 0.8
Ink System Unit
Dowel and Hole