Epson Stylus Photo 1500W - S T a R T J O B J S N N 0 0 H 0 0 H < J O B N a Me > M1; E N D J O B J E 0 1 H 0 0 H 0 0 H

2013/Feb/08
Revision: 1 Page: 57
6.1.7. Start job “JS” nn 00H 00H <job name> m1
6.1.8. End job “JE” 01H 00H 00H
[Format]
“JS” nL nH 00H <job name> m1
“JE” 01H 00H 00H
nL = (length of <job name>) + 2
nH = 00H
[Parameters]
The parameter “m1” is one byte binary data that fixed to zero.
[Function]
Construct a print job, and turn page and line position reply on/off, and set the position reply repeat rate if
the position reply is enabled.
If the host uses the cancel job command or it needs the page and line position reply, it must send print
data as a print job.
The print job is started with the “JS” command and terminated with the “JE” command. After starting a
job with the “JS”, if the “JS” is sent again without the “JE”, theprevious print job will be terminated
with the second “JS”.
After power-on initialization, the print job is not defined, and position reply is disabled.
This command is available only in Remote.