Epson Stylus Photo R390 - Page 135

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Maintenance Overview 136
Figure 6-20. Lubrication of the LD Roller Shaft (3)
LUBRICATION OF LEFT/RIGHT STACKER GUIDE
Figure 6-21. Lubrication of the Stacker Guides
<Lubrication Points>
Contact point between the LD Roller
and Hopper, ASF Gear
<Type>
G-71
<Application Amount>
ø 1 x 1/4-circle x 4 points
<Application Timing>
Apply before assembling the LD Roller
Holder
<Remarks>
Apply with Injector
 Rotate the LD Roller Shaft so that
the Curved/Flat surface face up, then
apply grease to the specified parts.
<Lubrication Points>
Along the groove of the Left/Right
Stacker Guides to where the CDR Guide
Shaft is set.
<Type>
G-77
<Application Amount>
Inner side of the groove x 2 points
<Application Timing>
Apply before assembling the CDR
Guide Shaft
<Remarks>
Apply with flux dispenser
LD Roller Shaft (Curved surface)
(Ribs beside the LD Roller)
Application Point
Left Stacker Guide
Right Stacker Guide
Application Point