Epson Stylus Photo R390 - Disassembling the Panel Unit

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Disassembly/Assembly Removing Control Boards 83
4.3.5 Disassembling the Panel Unit
 Panel Board removal
 Removing the Right/Left Laminated Panels (R360/R380/R390 only)
1. Disengage the four hooks on the rear side of the Panel Unit.
2. Push section of the Left Laminated Panel as indicated with the arrow to
disengage the tabs, and remove it.
3. Remove the Right Laminated Panel in the same manner.
Figure 4-67. Removing the Left/Right Laminated Panels

Removing the Panel Board (for R360/R380/R390)
1. Peel off the acetate tape.
2. Disengage the Ferrite Core from the hook.
Figure 4-68. Removing the Panel Board (1)
3. Disconnect the FFCs from CN1 connector on the Panel Board and CN1
connector on the LCD Board.
4. Remove the six screws, taking care not to damage the cables connecting the
two Panel Boards, remove the Shield Plate PNL in the direction of the arrow.
• Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm)
Figure 4-69. Removing the Panel Board (2)
C A U T I O N
Be careful not to scratch or damage the exterior surface (coated or
decorative laminated parts) during disassembly and reassembly.
C H E C K
P O I N T
Since the R260/R265/R270 are not equipped with a LCD panel, the
removal procedure of the Panel Board differs from that of the
R360/R380/R390. The procedure for the R260/R265/R270 is given
on the page below.
•Removing the Panel Board (for R260/R265/R270) on page 84
[Rear side]
: Hooks
[Front side]
: Tabs
Laminated Panel (L)
Laminated Panel (R)
Ferrite core
Acetate tape
Ferrite core
Hook
Shield Plate PNL
CN1
Removal Direction
CN1
: Positioning
section
Cables connecting the
two Panel Boards.