Epson Stylus Photo R390 - Page 45

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Troubleshooting Troubleshooting by Error Message 46
When printing on
CDs/DVDs
The CDR Tray center detection
sequence is interrupted, and the tray
is ejected.
PW Sensor
1. Is there any paper dust or ink stain on the PW
Sensor?
1. Clean off any dirt on the PW Sensor.
4.5.12 "CR
Unit"(p.105)
2. Is the PW Sensor cable not connected to the CR
Encoder Board and the PW Sensor?
2. Connect the PW Sensor cable to the CR
Encoder Board and the PW Sensor.
PW Senor
3. Is the PW Sensor cable broken? 3. Replace the CR Unit.
4.5.12 "CR
Unit"(p.105)
4. Is the PW Sensor damaged? 4. Replace the CR Unit.
Main Board
1. Is there any chipped or broken elements on the
Main Board?
1. Replace the Main Board.
4.3.2
"Removing the
Main Board
Unit"(p.78)
Table 3-10. Troubleshooting for CDR Tray Error
Occurrence
Timing
Symptom Failed Part Check Point Remedy Reference
CR Encoder
Board
Cable
PW Sensor