21
| 21
See the appropriate section to set up client systems for printing:
• “Setting Up Macintosh OS X Clients to Print to a Mac OS X RIP
Server” below
• “Setting Up Windows Clients to Print to a Mac OS X RIP Server” on
page 24
• “Setting Up Windows Clients to Print to a Windows RIP Server” on
page 30
Setting Up Macintosh OS X Clients to Print to a
Mac OS X RIP Server
1. Make sure your computer is connected to the same network as the
ColorBurst RIP server computer.
2. Insert the ColorBurst RIP CD-ROM in the CD-ROM or DVD drive.
3. Double-click the CD-ROM icon, then double-click
the
ColorBurst Client Installer icon.
4. When you see this screen, enter your Mac OS X
Admin password, then click
OK.
5. Follow the on-screen instructions to install the ColorBurst client
software.
6. When installation is complete, check the ColorBurst RIP server
computer to make sure ColorBurst is running.
Setting Up
Client Systems
Note: To print with both
Macintosh and Windows
clients, you must install
the RIP server software
on a Macintosh server.
See page 7.
Note: You can also find
the PPD installer in the
ColorBurst RIP for
Epson > Utilities folder
on the server. Copy the
file to the system where
you want to install it, then
double-click the installer
icon.
ColorBurst.book Page 21 Thursday, September 9, 2004 12:41 PM
To Next Page
Loading...
