Epson Stylus Pro 4000 - Installing and Setting Up the ColorBurst RIP Server; Server Setup for Macintosh OS X

7
| 7
You can install and set up the ColorBurst RIP server software on a
Macintosh OS X system or a computer running Windows XP or 2000. See
the appropriate sections:
• “Installing the ColorBurst Server Software for Macintosh OS X” below
• “Setting Up the ColorBurst RIP Server for Macintosh OS X” on page 8
• “Installing the ColorBurst RIP Server Software for Windows” on
page 15
• “Setting Up the ColorBurst RIP Server for Windows” on page 17
Installing the ColorBurst Server Software for
Macintosh OS X
Before you begin, make sure you have:
• Set up the Epson Stylus Pro 4000 and installed the standard Epson
printer driver on the computer you intend to use as your ColorBurst
RIP server (see your Epson
®
printer documentation for instructions)
• Connected the printer to the server using the USB interface
(recommended method) or connected the printer to an Ethernet
network and assigned it an IP address (see the documentation that came
with the included network card)
• Closed all open programs and turned off any virus protection programs
Follow these steps to install the server software:
1. Insert the ColorBurst RIP CD-ROM in your CD-ROM or DVD drive.
2. Double-click the CD-ROM icon, then double-click the
ColorBurst RIP Installer icon.
Installing and
Setting Up
the Server
Software
ColorBurst.book Page 7 Thursday, September 9, 2004 12:41 PM