56
56 | Color Management and Printer Linearization
10. Click Connect to enable your spectrophotometer, then click Start and
follow the instructions for positioning your spectrophotometer or for
manually reading in the target patches.
11. Once you have read all of the patches on the linearization chart, save
your file in the LIN folder and name it accordingly. Make sure you have
saved the file in the LIN folder.
12. Open ColorBurst.
Note: If you are using
the DPT41, use the
ColorBurst DPT41 reader
software located in the
LIN folder.
ColorBurst.book Page 56 Thursday, September 9, 2004 12:41 PM
To Next Page
Loading...
