9
Installing and Setting Up the Server Software | 9
3. When you see this message, click OK.
4. When you see this message, click
OK.
5. Type a name for the printer in the Printer Name box. It can be any
name you want. This name is used only within the RIP/server interface
and is not the name that will be used on the network. (See “Setting the
Print Server Name” on page 13 to change the RIP name used on the
network.)
6. Choose
USB or Ethernet as the Printer Connection setting.
7. Choose
Stylus Pro 4000 from the Which Printer list that appears, if
necessary.
If you see the message “There are no printers connected to this
computer using USB,” check your USB connection and make sure the
printer is set up and turned on as described on your Stylus Pro 4000
Start Here sheet.
ColorBurst.book Page 9 Thursday, September 9, 2004 12:41 PM
To Next Page
Loading...
