R4CD400
Setup Guide Rev. C
ENGLISH.FM A4 size
12/15/04
R
Proof Sign-off:
KOW M.Arai K.Nishi
K.Nishi
NOC K.Lee
9
English
7. Hold both the fixed and movable flanges, and
rewind the paper to the line marked with an
arrow mark.
8. Move the paper lever to the secured position.
The printer automatically feeds the paper to
the printing position.
9. Close the roll paper cover.
10. Raise the roll paper support.
11. Extend the paper tray and the paper tray cover
according to the paper length to be used for
printing.
12. Press the Paper Source button to select Roll
Auto Cut On on the LCD.
c
Caution:
Do not leave the paper in the printer for a long
period of time; its quality will deteriorate. We
recommend that you remove the paper from the
printer after printing.
Loading Cut-Sheet Paper
To load cut-sheet paper in the paper tray, follow
the steps below.
Note:
This section describes loading cut-sheet paper smaller
than A3 size. If you want to load A3 or a larger paper,
or if you want to know the details of paper handling, see
"Paper Handling" in the Reference Guide included on
the Printer Software CD-ROM shipped with your
printer.
1. Make sure the printer is on and in the READY
state.
2. Press the Paper Source button to select
Sheet
on the LCD.
To Next Page
Loading...
