Epson Stylus Pro 7890 - Page 26

Epson Stylus Pro 9890/9908/7890/7908 User’s Guide
The Control Panel
26
CUSTOM PAPER
When you use non-Epson media, you need to make settings suitable for the media.
After you have selected the paper number, make the following settings. Make sure to select the paper
from PAPER TYPE first, and then make the PLATEN GAP setting and so on.
To set the custom paper, see the following section.
“Printing on custom paper” on page 145
Item Parameter Explanation
PAPER TYPE Photo Paper You can select the media type that is most similar to the
paper you are using.
Proofing Paper
Fine Art Paper
Matte Paper
Plain Paper
Others
PLATEN GAP NARROW You can adjust the distance between the print head
and paper.
STANDARD: Normally, select STANDARD.
NARROW: Use this when printing on thin paper.
WIDE or WIDER: Select this if you find that printed images
are smeared.
STANDARD
WIDE
WIDER
THICKNESS PATTERN PRINT You can print the paper thickness detection pattern.
PAPER FEED ADJUST 0.00% You can set the paper feed amount of the printable
area. The range is -0.70 to 0.70%. If the paper feed value
is too large, white horizontal micro-banding may
appear. If the paper feed value is too small, dark
horizontal micro-banding may appear.
-0.70% to +0.70%
DRYING TIME 0.0sec You can set the ink drying time for each print head
pass. The range is 0 to 10 seconds. Depending on the
ink density or paper type, the ink does not dry soon. In
this case, set the drying time longer.
0.0sec to 10.0sec
PAPER SUCTION STANDARD You can set the suction pressure used to feed the
printed paper.
-1 to -4
SET ROLL PAPER
TENSION
NORMAL When using a cloth or thin paper or when wrinkles
appear in the paper during printing, select HIGH or EXTRA
HIGH.
HIGH
EXTRA HIGH
REMOVE SKEW ON You can select whether to perform this operation to
reduce the paper skew or not.
OFF