Epson Stylus Pro 7890 - Details of Menu Mode

Epson Stylus Pro 9890/9908/7890/7908 User’s Guide
The Control Panel
21
Details of Menu mode
PRINTER SETUP
Item Parameter Explanation
PLATEN GAP NARROW You can adjust the distance between the print head
and paper.
❏ STANDARD: Normally, select STANDARD.
❏ When selecting other than STANDARD, the following
icon appears on the LCD panel.
: NARROW
: WIDE
: WIDER
: WIDEST
STANDARD
WIDE
WIDER
WIDEST
PAGE LINE ON You can select whether to print a page line (line along
which to cut) on the roll paper. Select ON if you want to
print the page line, or OFF otherwise.
The vertical line may be printed when the roll paper
width that is set in the printer driver is smaller than the
width of the roll paper that is loaded in the printer.
This setting is available for roll paper only.
OFF
ROLL PAPER MARGIN DEFAULT You can select margins for roll paper.
❏ DEFAULT:
The top margin of Premium Glossy Photo Paper
(250), Premium Semigloss Photo Paper (250), and
Premium Luster Photo Paper (260) are 20 mm and
the bottom margin is 15 mm.
❏ TOP/BOTTOM 15mm:
The top and bottom margins are 15 mm and left
and right margins are 3 mm.
❏ TOP 35/BOTTOM 15mm:
The top margin is 35 mm, bottom is 15 mm, and left
and right are 3 mm.
❏ 15mm:
The margins of all four sides are 15 mm.
❏ 3mm:
The margins of all four sides are 3 mm.
The print size does not change even when the margins
are changed.
TOP/BOTTOM15mm
TOP 35/BOTTOM 15mm
15mm
3mm
PAPER SIZE CHECK ON You can select whether to check the paper width.
❏ ON:
Check the paper width and top edge of the paper.
❏ OFF:
Do not check the paper width and top edge of the
paper. The printer continues to print even if the
paper width does not match the data width, and
the printer may print beyond the paper. Because
this soils the inside of the printer, we recommend
you select ON. This may result in a wider blank margin
at the top of each page.
OFF