Epson Stylus Pro 9890/9908/7890/7908 User’s Guide
The Control Panel
27
HEAD ALIGNMENT
You can perform print head alignment. For more details, see the following section.
“Print head alignment” on page 82
NETWORK SETUP
When you use the printer on the network, set the following items.
Item Parameter Explanation
PAPER THICKNESS SELECT PAPER TYPE When using Epson special media, select the paper
type. If you use non-Epson special media, enter the
paper thickness in the range of 0.1 to 1.5 mm.
SELECT THICKNESS
ALIGNMENT AUTO When you select AUTO, the adjustment pattern for
output is read by the sensor and the optimum
adjustment value is registered automatically in the
printer. When you select MANUAL, you need to check the
pattern and enter the value for alignment.
MANUAL
Item Parameter Explanation
NETWORK SETUP DISABLE You can make the network settings using the printer’s
control panel. The following items appear only when
ENABLE is selected. After setting the items, press the
button in the NETWORK SETUP menu, so the network is
reset and the network connection is available after 40
seconds. The NETWORK SETUP menu does not appear
while resetting the network.
ENABLE
IP ADDRESS SETTING AUTO You can select the method to set the IP address to the
printer. When you select PANEL, IP,SM,DG SETTING
appears.
PANEL
IP,SM,DG SETTING Ask your system administrator for detailed information.
BONJOUR ON You can enable or disable the Bonjour setting.
OFF
WSD OFF Select whether the network interface uses WSD (ON) or
not (OFF).
ON
INIT NETWORK SETTING EXECUTE You can return the network settings of the printer to the
factory default value.
To Next Page
Loading...
