Epson Stylus Pro 9890/9908/7890/7908 User’s Guide
Paper Handling
34
N
Insert the paper into the insertion slot. Pull
the paper down through the paper
insertion slot so that it comes out below.
Take care not to fold the edge of the paper,
and insert it so that there is no slack.
If you have difficulty feeding the paper,
adjust the paper suction by pressing the
or button. Pull the paper to fit the edge
of the paper to the label position.
O
Close the roll paper cover.
P
Press the button.
After a few seconds, the paper moves to the
printing position. When you press the
button, it moves immediately.
Q
If ARE THESE SETTINGS OK? appears on the
LCD panel, press the or button to
select NO and then press the button. Set
the media type and paper remaining, and
then press the button to set the media.
The previous setting appears on the LCD
panel. If the media type and paper
remaining are correct, select YES and then
press the button.
R
If the edge of the roll paper has folds, press
the button to cut the edge.
S
When using the paper basket, set it in the
forward or backward position.
If you are using Epson Stylus Pro
9890/9908, you can also use the optional
Auto Take-up Reel Unit.
See “Using the paper basket and paper
guides” on page 42
See “Using Auto Take-up Reel Unit (For
Epson Stylus Pro 9890/9908 only)” on page
46
To Next Page
Loading...
