Epson Stylus Pro 7890 - Page 73

Epson Stylus Pro 9890/9908/7890/7908 User’s Guide
Maintenance
73
E
Press the button.
The paper cutter holder stops at the
replacement position.
F
If the optional SpectroProofer Mounter is
attached to the printer, remove it from the
printer and then turn off the printer.
See the SpectroProofer Mounter 24"/44"
User’s Guide for details on removing it from
the printer.
G
To remove the cover, lower it with the
knob, and pull it low.
H
Screw down the cutter with a screwdriver.
I
Carefully remove the old cutter from the
printer.
J
Take the new paper cutter out of the
package and insert it as shown.
Install the cutter into the cutter holder,
setting the pin of the cutter to the hole of the
holder.
w
Warning:
Take care not to hurt yourself with the
blade of the cutter. Do not let children
touch the blade.
Note:
Put the used cutter in a bag or the like, and
dispose of it in accordance with local
regulations.