Epson Stylus Pro 9000 - Troubleshooting

Troubleshooting
123
Jamaica
Long.bk Rev. C
A5 size trble.fm
2/22/99 Pass 2
R
Proof Sign-off:
Miyazaki _______
Yamanouchi _______
Jacqueline _______
LOAD ROLL PAPER
LOAD SHEET PAPER
o
Paper Out
The paper source
setting in the printer
driver is different from
the control panel.
Make sure the paper
source setting in the
printer driver is the same
as the control panel.
PAPER JAM
f
Paper Out
Paper is jammed in
the printer.
Remove the jammed
paper. See also “Paper
Feed or Paper Jam
Problems Occur
Frequently” on page
136.
COVER OPEN Lower cover is open. Close the lower cover.
PAPER NOT CUT
f
Paper Out
Roll paper was not
cut.
Cut the paper manually,
then remove the cut
paper from the printer.
When RELOAD PAPER is
displayed, load paper.
Cut paper did not fall
off.
Remove the cut paper
from the printer. When
RELOAD PAPER is
displayed, load paper.
PAPER NOT
STRAIGHT
f
Paper Out
Slippage occurred
and paper was fed at
an angle.
Reload paper. See
“Paper Feed or Paper
Jam Problems Occur
Frequently” on page
136.
RELOAD PAPER
f
Paper Out
Paper could not be
reversed into the
printing position.
Remove then reload the
paper so that the right
and bottom edges are
straight and in line with
the rows of punch holes
on the printer. See
Chapter 4, "Paper
Handling".
Paper is set out of the
printable area.
Paper is set out of the
horizontal cutting
area.
Paper is not fully
ejected.
Cut the paper at the
paper insertion slot, then
reload paper.
PAPER NOT CUT error
was cleared.
Reload paper.
o= On, f= Flashing, n= Off
Message and Light Problem Solution