Epson Stylus Pro 9000 - Cut Sheet Media Handling

Paper Handling
93
Jamaica
Long.bk Rev. C
A5 size PAPER.FM
2/22/99 Pass 2
R
Proof Sign-off:
Miyazaki _______
Yamanouchi _______
Jacqueline _______
Cutting the roll paper at other times
1. Press the
Paper Feed
button to position the paper in place
for cutting.
2. Press the
Paper Source
button repeatedly until the Roll Auto
Cut light is on.
3. Press the
Cut/Eject
button. The roll paper is cut.
Printing page lines
If you want to print continuously on roll paper first, then cut the
page yourself after you finish printing, use the Print Page Line
setting. To make the Print Page Line setting using the control
panel, see “SelecType Settings” on page 16. To use the printer
software, see “Using the Roll Paper Settings” on page 46.
Using Cut Sheet Media
Loading cut sheet media
To load cut sheet media, follow the steps below. To load thick
paper (0.5 mm or thicker), see “Printing on thick paper (0.5 mm
or thicker)” on page 96.
Note:
You may want to set the paper basket before printing. See “Setting the
Paper Basket” on page 98. (In the illustrations below the paper basket is
set to feed paper backwards.)
1. Make sure that the printer is on and the roll paper cover is
closed.
2. Press the
Paper Source
button repeatedly until the Sheet
light is on.