Epson Stylus Pro 9000 - Page 28

The Control Panel
28
Jamaica
Long.bk Rev. C
A5 size CONTP.FM
2/22/99 Pass 2
R
Proof Sign-off:
Miyazaki _______
Yamanouchi _______
Jacqueline _______
Paper thickness test pattern example:
6. See the printed pattern to determine which set of lines are
aligned (show the smallest gap), and note the corresponding
number.
7. You may see
PAPER THICK. NO. = 1*
. Press the + or - button
to select the number noted in step 5.
Note:
The default value depends on the PAPER THICK. value in the Head
Alignment menu and is displayed as a PAPER THICK. NO. in the
Paper Configuration menu as shown below:
8. Press the
Item
button.
DRYING TIME
appears. Press the + or -
button to select time in minutes.
9. Press the
Pause
button to exit the SelecType mode.
Selecting the registered settings
To select the registered settings, follow the steps below.
1. In the SelecType mode, press the
SelecType
button until
PAPER CONFIG. MENU
appears on the LCD panel.
2. Press the
Item
button. You may see
PAPER NUMBER=1*
.
PAPER THICK. value PAPER THICK. NO.
0.0 mm
to
1.6 mm
1
to
17
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17
smallest gap