7
❏
Make sure the printable side of the paper is facing up when
loading media into the paper feeder. See the instruction sheets
packed with the media to determine which side is the
printable surface. Some media have cut corners to help
identify the correct loading direction, as shown in the
illustration.
Note:
If you extend the printable area by selecting the
Maximum
setting
in the printer driver, the cut corner on special paper may mar your
printout.
❏
Make sure the paper stack fits under the arrow mark located
on the inside surface of the left edge guide.
❏
Remove any documents from the document feeder before
printing using the paper feeder.
cut corner
printable
side up
To Next Page
Loading...
Need help?
General
