Epson Stylus Scan 2000 Manual

171
❏
Do not attempt to service the EPSON Stylus Scan yourself.
❏
Unplug the Stylus Scan and refer servicing to qualified service
personnel under the following conditions:
The power cord or plug is damaged; liquid has entered the
Stylus Scan; the Stylus Scan has been dropped or the cabinet
damaged; the Stylus Scan does not operate normally or
exhibits a distinct change in performance.
❏
If you are using the Stylus Scan in Germany, observe the
following:
To provide adequate short-circuit protection and over-
current protection for this Stylus Scan, the building
installation must be protected by a 16 Amp circuit breaker.
Bei Anschluß des Druckers an die Stromversorgung muß
sichergestellt werden, daß die Gebäudeinstallation mit einem
16 A- Überstromschalter abgesichert ist.
A Few Precautions
When using the Stylus Scan
❏
Do not put your hand inside the Stylus Scan or touch the print
head during operation.
❏
Do not move the print head by hand. Doing so may damage
the EPSON Stylus Scan.
❏
Always turn of the Stylus Scan using the
P
power button.
When this button is pressed, the
P
power light flashes briefly
and then goes off. Do not unplug the Stylus Scan or turn off
the power to the outlet until the
P
power light stops flashing.

Epson Stylus Scan 2000 Specifications

General

Brand	Epson
Model	Stylus Scan 2000
Category	All in One Printer
Language	English