16 | Completing setup and connecting the power cord
Completing setup and connecting the power cord
1. Unlock the casters and move the printer to its final location. Lock the casters after moving the printer.
Note: The casters are only meant for moving the printer a short distance over smooth surfaces.
2. Remove any packing tape and plastic film. Check these areas:
• front cover
• ink compartment covers
• maintenance tanks
3. Open the roll paper cover and remove the tape and packing material.
4. Open the front cover and remove the tape and packing material.
Note: Save the packing material in case you need to ship the printer.
5.
Close the front cover.
To Next Page
Loading...
