Version 3.00 Feb. 2019
APPLICATION DEVELOPMENT GUIDE
CheckScanner
6
When the dialog box is displayed, press the [Read] button. The checks to be
read here are read in accordance with the set mode by
CHK_DI_CHANGE_MODE of DirectIO. If the Check is present, please first
remove and then set the check in slip station. If a check or card is set correctly,
data will be read. If a check or card is not set, a message requesting for
inserting a check or card will be displayed. After inserting the check or card,
press the [Read] button. Then the check or card is read. Reading takes from a
few seconds to dozens of seconds. Confirm the reading state on the progress
bar. The read data appears as an image in the dialog box, and the image format
is fixed at bitmap. For CheckHealth, part of the image is read in and displayed.
Confirm the contents.
When the method is executed by OPOS_CH_INTERACTIVE, the character
strings of the CheckHealthText property are as follows.
“Interactive Hcheck: Canceled” : When the [Close] button is pressed
without executing the [Read].
“Interactive Hcheck: Complete” : When the [Close] button is pressed after
executing the [Read].
After executing the CheckHealth method, be sure to confirm the returned value.
If an error has occurred, there is no point in referring to the CheckHealthText
property. For details on the error, please refer to Section 6 of this manual.
To Next Page
Loading...
