60
Chapter 3 Advanced Usage
Batch rotate print (Upside Down)
When the printer is installed so that the paper is ejected frontward, enable this function to print in an easy-to-
view orientation.
• Enable
• Disable (initial setting)
Method for canceling recoverable error
• Command only
• Command, and close of the roll paper cover (initial setting)
Handshaking (Condition for BUSY)
• Receive buffer full/Offline (initial setting)
• Receive buffer full
Receipt Enhancement
You can configure settings such as logo placement when automatically printing a registered logo.
Automatic top logo printing
• Key code
• Justification
• Number of deleted lines after top logo printing
Automatic bottom logo printing
• Key code
• Justification
Advanced settings for automatic top/bottom logo printing
• Print the top logo when paper is fed to the cut position (initial setting: Enabled)
• Print the top logo when the printer is turned on (initial setting: Disabled)
• Print the top logo when the cover is closed (initial setting: Enabled)
• Print the top logo when the buffer is cleared during a recoverable error (initial setting: Enabled)
• Print the top logo when feeding paper using the feed button is completed (initial setting: Disabled)
In either case above, the printer enters the BUSY state after power is turned on, and when a self-test
is being run.
To Next Page
Loading...
