This is the end of the printer driver installation. For information on how to print using the printer driver.
U See “Using the Printer Driver” on page 41
Network Address Setting for Ethernet Printer
If you are using an Ethernet connection, configure the IP address using the EpsonNet Config.
A
Start the EpsonNet Config.
When the EpsonNet Config is already installed, start it by clicking Start - All Programs - EpsonNet - EpsonNet
Config Vx - EpsonNet Config.
B
The EpsonNet Config screen appears.
Check that the target printer is listed in the screen.
C
Select the printer you want to configure, then click the Configuration button.
When the printer does not appear, click the Refresh button.
D
The Device Properties screen appears. Select the Network Interface - TCP/IP - Basic.
TM-T20II Software Installer Software User's Manual
Installation
18
To Next Page
Loading...
