B
Configure the following items referring to the preview on the right portion of the screen.
Note:
Settings other than Extra Upper Space Reduction and Extra Lower Space Reduction are disabled due to the
Advanced Printer Driver being in graphics mode.
Setting Description
Extra Upper Space Reduction Selects whether to reduce the upper margin or not. Enable this to cut out the
extra upper margin that is created before the first print data is printed.
Extra Lower Space Reduction Selects whether to reduce the lower margin or not. Enable this to cut out the
lo wer mar gin tha t is c rea ted fro m the tim e the last line is printed until the paper
is automatically cut.
Line Space Reduction Rate Selects a reduction ratio of line spacing during printing. The minimum pitch is
two dots. If reduction results in a line spacing of less than 2 dots, the line
spacing will be reset to 2 dots.
Line Feed Reduction Rate Selects a reduction ratio of line spacing of blank lines. This setting is ignored for
the portion set to be cut out by the Extra Upper Space Reduction setting. When
you advance the paper by inserting line feeds in order to cut the paper
manually, you may not be able to advance the paper until the last line reaches
the cut position because of this reduction setting.
Barcode Height Reduction Rate Selects a reduction ratio of barcode height. The barcode height cannot be
reduced to less than 30-dots height. This setting can cause the barcode size to
fall outside the barcode standards.
C
Click the Set button. The settings are reflected to the printer.
Automatic Paper Cut Settings
Allows you to configure whether to cut paper and print a logo when the cover is closed.
TM-T20II Software Installer Software User's Manual
TM-T20II Utility
71
To Next Page
Loading...
Need help?
General
