Select Mode for Storing Logo has the following functions. The current setting is displayed below Storing Logos.
Setting Description
First Key-code Selection Mode Specifies the logo identifying code.
Automatically set the key-code for the logo to be stored. If this is turned on, automatically sets Key-codes to the logos
to be registered. If turned off, sets Key-codes when adding or
editing logos.
Advanced Printer Driver Control Font Setting Mode The Advanced Printer Driver allows you to assign a control
font (h to l) to your logo instead of using a key code.
Key-code Nonuse Mode (not recommended) Not recommended.
Key-code Management has the following functions. You can check the Key-code of the logo stored in the printer, or
delete the logos.
Setting Description
Get KeyCode Obtains registered Key-code numbers.
TM-T20II Software Installer Software User's Manual
TM-T20II Utility
66
To Next Page
Loading...
