Epson TM-T88 User Manual

1-6 Setting Up the Printer
WARNING:
Make sure that you use the EPSON PS-170 power supply or
equivalent. Using an incorrect power supply may cause fire or
electrical shock.
CAUTIONS:
When connecting or disconnecting the power supply from
the printer, make sure that the power supply is not plugged
into an electrical outlet. Otherwise you may damage the
power supply or the printer.
If the power supply’s rated voltage and your outlet’s voltage
do not match, contact your dealer for assistance. Do not
plug in the power cord. Otherwise, you may damage the
power supply or the printer.
1. Make sure that the printer’s power switch is turned off, and the
power supply’s power cord is unplugged from the electrical
outlet.
2. Check the label on the power supply to make sure that the
voltage required by the power supply matches that of your
electrical outlet.
3. Plug in the power supply’s cable as shown below. Notice that
the flat side of the plug faces down.
Note:
To remove the DC cable connector, make sure that the power
supply’s power cord is unplugged; then grasp the connector at the
arrow and pull it straight out.

Epson TM-T88 Specifications

General

Print Method	Thermal Line Printing
Resolution	180 dpi
Auto Cutter	Yes
Printer Type	Receipt printer
Interfaces	USB, Serial, Ethernet
Paper Roll Diameter	83 mm
Power Consumption	1.8W (Standby)
Paper Width	80 mm or 58 mm (with paper width guide)
Power Supply	Internal (depending on the model) or External