1-2 Installation
Removing the Transportation Damper
The printer is protected during shipping by a transportation
damper that must be removed before you turn on the printer.
1. Pull the damper out and remove the strip of tape from the top
of the printer, as shown below.
Note:
If you ever ship or store your printer, prepare it by performing these
steps: turn on the printer, press the RELEASE button, press the
FORWARD button, turn off the printer, and put the transportation
damper back where it was when you received the printer.
Connecting the Printer to the Computer
You need an appropriate interface cable to connect your computer
to the printer.
To Next Page
Loading...
Need help?
General