5-20 Commands
Hex 1B 63 33
n
Decimal279951
n
[Range] 0 ≤
n
≤ 255
[Description] Selects paper sensor(s) to output paper end signals, using
n
as
follows:
[Notes] • It is possible to select multiple sensors to output signals. Then, if
any of the sensors detects a paper-end, the paper end signal is
output.
• This command is available only with a parallel interface and is
ignored with a serial interface.
[Default]
n
= 0
ESC c 4
n
[Name] Select paper sensor(s) to stop printing
[Format] ASCII ESC c 4
n
Hex 1B 63 34
n
Decimal279952
n
Bit Off/On Hex Decimal Function
0
Off 00 0 Undefined.
On 01 1 Undefined.
1
Off 00 0 Undefined.
On 02 2 Undefined.
2
Off 00 0 Undefined.
On 04 4 Undefined.
3
Off 00 0 Undefined.
On 08 8 Undefined
4
Off 00 0 TOF sensor disabled.
On 10 16 TOF sensor enabled.
5
Off 00 0 BOF sensor disabled.
On 20 32 BOF sensor enabled.
6
Off 00 0 Undefined.
On 40 64 Undefined.
7
Off 00 0 Undefined.
On 80 128 Undefined.
To Next Page
Loading...
