Epson WF-2010 - Page 55

Confidential
Adjustment Required Adjustments 55
WF-2540 / WF-2530 / WF-2520 / WF-2510 / WF-2010 series Revision B
Part Name
LD Roller Assy
Remove
--- --- ---
Replace
--- --- ---
CR Motor
Remove
--- --- ---
Replace
--- --- ---
PE Sensor Lever
Remove
--- --- ---
Replace
--- --- ---
Main Board
Remove
--- --- ---
Replace (Read OK)
--- --- ---
Replace (Read NG)
--- --- ---
CR Driven Pulley
Remove
--- --- ---
Replace
--- O ---
Main Frame Assy
Remove
--- --- ---
Replace
OO---
Paper Guide Upper Assy
Remove
--- --- ---
Replace
--- --- ---
CR Unit
Remove
--- --- ---
Replace
O --- ---
CR Timing Belt
Remove
--- --- ---
Replace
--- O ---
Frame Base Assy Replace
--- --- O
PF Roller Unit
Remove
--- --- O
Replace
--- --- O
PF Motor Assy
Remove
--- --- O
Replace
--- --- O
Frame Base Replace
--- --- O
PIS Board
Remove
--- --- ---
Replace
--- --- ---
Table 3-1. Required Adjustment List
Adjustment Type Mechanism adjustment
Priority
1 2 3
Adjustment Item
Checking the Platen
Gap
CR Belt tension check PF Belt tension check
Purpose
Check if the PG is within
the standard.
Check the tension of the
CR Timing Belt
Check the tension of the
PF Timing Belt
Printout pattern
--- --- ---
How to judge
See " 3.3.1 Checking the
Platen Gap (p63)" for
the details.
See " 3.3.2 CR/PF Belt
Tension Check (p65)"
for the details.
See " 3.3.2 CR/PF Belt
Tension Check (p65)"
for the details.
Adjustment program
--- --- ---
Tool See p63 See p65 See p65
Note 1: Necessary when the part is replaced at a point in the disassembly procedures other than specified in this manual.
2: Replacement of the Paper Guide Lower Porous Pad and Waste Ink Pad Assy is necessary.