Epson WF-4740 - Page 43

43
2. Make sure Simple AP mode or Wi-Fi Direct is enabled on your product and that you are using the
default Wi-Fi Direct password.
Note: NFC printing and scanning will not work if you changed the Wi-Fi Direct password from the
default.
3. Do one of the following:
• If you are going to print, make sure paper is loaded in the product.
• If you are going to scan, place your original on the product for scanning.
4. Touch the NFC antenna of your mobile device to the NFC tag on your product.
Note: The location of your mobile device's NFC antenna varies. See your mobile device
documentation for more details.
Epson iPrint opens on your device.
Note: If you do not have Epson iPrint installed, the app store page for the Epson iPrint app opens on
your device. Install Epson iPrint and repeat this step.
5. Touch the NFC antenna of your mobile device to the product NFC tag on your product again.
The printer and mobile device connect.
Note: If the mobile device and product disconnect, try to print or scan a document. The mobile
device and product should reconnect automatically.