Epson WF-5690 Series - Lubrication Points and Instructions (cont.); Carriage Assy Lubrication Points

Epson WF-5690/4640/4630/5620/5190/5110 series Revision D
Confidential
Maintenance Lubrication Points and Instruction 86
Figure 4-10. Lubrication of the Carriage Assy
<Lubrication Point>
1. Contact surfaces (x2)
of the Carriage Assy
with the APG Cam
2. Contact points (x2) on
the APG Cam with the
APG slider
3. Contact points (x4) on
the APG Slider with
the CR Guide Frame
4. Contact point on the
CR Sub Slider with the
Main Frame
5. Contact surfaces (x2)
of the Carriage Assy
with the CR Guide
Frame
6. Contact points (x2) on
the CR Front Slider
Left/Right with the CR
Guide Frame
7. Contact points (x2) on
the CR Rear Slider
with the CR Guide
Frame
<Type>
G-71
<Application Amount>
1. 0.02 g
2. 0.02 g
3. 0.05 g
4. 0.02 g
5. φ 1 mm x 0.05 g
6. 0.05 g
7. 0.05 g
<Remarks>
 Apply with injector.
 For 1, 2, 3, 4, 6 and 7,
spread grease with
brush as shown in the
figure after application
with injector.
Bottom
APG Slider
Application point 3
CR Rear Slider
CR Front Slider Right
Application point 6
Right
Application point 5
Contact surface of Carriage
Assy with CR Guide Frame
CR Front Slider Left
Application point 6
Apply on steps
APG Cam
Application point 2
Apply on projections
Application point 1
Contact surface of Carriage
Assy with CR Guide Frame
Left
Application point 5
Carriage Assy
CR Sub Slider
Application point 7
CR Rear Slider
Application point 4
CR Front Slider Right