28
Operation
1. Check the product, its power cord and plug as well as accessories for damage
before each use. Do not use the product if it is damaged or shows wear.
2. Double check that the accessories and attachments are properly xed.
3. Always hold the product on its handles. Keep the handles dry to ensure safe
support.
4. Ensure that the air vents are always unobstructed and clear. Clean them if
necessary with a soft brush. Blocked air vents may lead to overheating and
damage the product.
5. Switch the product off immediately if you are disturbed while working by other
people entering the working area. Always let the product come to complete stop
before putting it down.
6. Do not overwork yourself. Take regular breaks to ensure you can concentrate on
the work and have full control over the product.
01
Spraying (Figs. O, P)
NOTE: Perform several spray tests to select the suitable spray pressure
by regulating the rotatable On/Off switch (18), and the correct paint/air
ratio by regulating the air cap (3), the air ow adjustment lever (7) and the
uid adjustment knob (8a). Start painting on the work surface after the
tests show a satisfactory result.
Always keep the product in a horizontal position or aim the spray head
at a slightly downward angle during painting. Paint cannot be applied
correctly when the spray head is aimed in an upward direction.
1. Set up a piece of cardboard or other scrap material to use as a target and adjust
for best spray pattern.
WARNING! Never aim or spray at yourself or anybody else. This may
cause serious injury.
MNL_Erbauer_GB_EPS800_800W paint sprayer_V1_201020.indd 28 10/20/20 5:03 PM
To Next Page
Loading...
