35
Troubleshooting
Suspected malfunctions are often due to causes that the users can x themselves.
Therefore check the product using this section. In most cases the problem can be
solved quickly.
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
by an authorised service centre or a similarly qualied specialist if you
cannot solve the problem yourself!
Problem Possible cause Solution
1. Product does
not start
1.1 Not connected to power
supply
1.1 Connect to power supply
1.2 Power cord or plug is
defective
1.2 Check by a specialist
electrician
1.3 Other electrical defect to
the product
1.3 Check by a specialist
electrician
2. Product does
not reach full
power
2.1 Extension cord not suitable
for operation with this
product
2.1 Use a proper extension
cord
2.2 Power source (e. g.
generator) has too low
voltage
2.2 Connect to another power
source
2.3 Air vents are blocked 2.3 Clean the air vents
3. Fluttering or
spitting
3.1 Not enough paint in the
paint container
3.1 Add paint
3.2 Suction tube not immersed
in paint
3.2 Add paint
3.3 Suction tube worn or
opening plugged up
3.3 Clean or replace suction
tube
3.4 Spray head tipped upward 3.4 Keep at horizontal position
or slightly downward
3.5 Spray nozzle loose, worn
or damaged
3.5 Tighten or replace spray
nozzle
3.6 Dry, worn or damaged
nozzle needle
3.6 Lubricate or replace nozzle
needle
MNL_Erbauer_GB_EPS800_800W paint sprayer_V1_201020.indd 35 10/20/20 5:03 PM
To Next Page
Loading...
